wordie08 Posted May 6, 2012 Share Posted May 6, 2012 Hi Has anyone taken a Bachmann HTA apart? If so was easy to do? as I am looking to fit a flashing tail light Regards wordie Link to post Share on other sites More sharing options...
Ian Fisher Posted May 6, 2012 Share Posted May 6, 2012 I have taken a HHA apart, if they are alike in build it seperates out to an undeframe, sides, ends and diecast inners that screw clip to the plastic. Ian Link to post Share on other sites More sharing options...
RMweb Premium dale159 Posted May 7, 2012 RMweb Premium Share Posted May 7, 2012 Hi Has anyone taken a Bachmann HTA apart? If so was easy to do? as I am looking to fit a flashing tail light Regards wordie Hi Wordie, I have dismantled an HTA in order to fit a tail light From what I remember you need to remove the bogie remove the screw which holds the coupling in and then remove the two screws which removing the bogie has revealed repeat this process at the other end of the wagon the body and chassis should now part company with a little manipulation of a few clips down each side Then the two ends of the hopper are big diecast steel blocks which are held in with 2 screws from the bottom, I only removed one block to fit the wires through. Once the light is in reassembly is just the reverse of the disassembly. Hope this helps Cheers Dale Link to post Share on other sites More sharing options...
wordie08 Posted May 8, 2012 Author Share Posted May 8, 2012 Hi Dale Thank you for the info will give this a go this week cheers Wordie Link to post Share on other sites More sharing options...
hammy Posted May 8, 2012 Share Posted May 8, 2012 Also did one of these as a working flasher it's in the weathering section blues street let's be weathering ya think there's a picture there Link to post Share on other sites More sharing options...
Recommended Posts
Archived
This topic is now archived and is closed to further replies.