Help with ratio lms signal kits

[kingfisher9147]

Hi all, I wonder if someone could help me with building ratio Lms signal kits. The one I am trying to build is the junction signal fig 3. I have done a Google search but unable to find a picture to help. 

Thanks mike

[uax6]

What are you struggling with?

Its a balanced doll type bracket, so the post to the ground goes in the middle of the 'deck', with the two dolls evenly spaced either side, as shown in the drawing bottom left.

 

Andy G

[kingfisher9147]

The part I'm having trouble with is the part where the two brass wire is join through the signals to the signals. I can't make out the parts clearly and which part of the kit they are from. As they are not numbered. If someone could highlight them on the photo of the parts. 

[John Isherwood]

16 minutes ago, kingfisher9147 said:

The part I'm having trouble with is the part where the two brass wire is join through the signals to the signals. I can't make out the parts clearly and which part of the kit they are from. As they are not numbered. If someone could highlight them on the photo of the parts. 

 

White sprue, top righthand components.

 

CJI.

[uax6]

If you are talking about the bits for the rocking bar that transfers the drive from the post to the front of the platform to the dolls, then those bits are tiny things on the white sprue, above the ladder. The double holer goes in the middle to support both drives, and then you use the angled single holers at each end of the platform, one pointing upwards, one pointing down. The two bits above I think are the bits that go on the end of the rod, but there should be another two somewhere, which I can't see.

 

Andy G

Edited January 17 by uax6

[kingfisher9147]

Thank you for the information and help. I have contacted peco to see if they have a better picture of signal to use to help.