Turnout Operating Units compatible with mechanical + point motor control?

[Lacathedrale]

All of the signals and turnouts for my layout are located on a single board (with the exception of one crossover). I am hoping that my layout will eventually have mechanical signal and point control.

 

Right now, my baseboard simply has a hole underneath each tie bar (Peco Bullhead Code 75) and I am using the pointy-finger method of actuation. 

 

I was/am planning on using the ScaleFour Society Lever frames but I'm not 100% on this yet. What's the easiest/cheapest/most expedient method of turnout actuation under the baseboard that can be connected to rodding from a lever frame? i was thinking of this: https://www.scaleseven.org.uk/index.php?id=117

 

 

Edited April 30, 2023 by Lacathedrale