MattB Posted September 2, 2021 Share Posted September 2, 2021 Just wondering if I can remove the plate at the end that all the wires go to and substitute with the decoder. Obviously I don't want to remove something if its needed. Model is a 32100 class 08. I know which wires go where and I'm putting in a 2 function TCS T1 which should fit in nicely. Loco tested and runs fine in analog Link to post Share on other sites More sharing options...
Waveydavey Posted September 2, 2021 Share Posted September 2, 2021 Remove the circuit board and cut off the two bosses that the attaching screws go into. Then hard wire in your new decoder. 2 Link to post Share on other sites More sharing options...
MattB Posted September 3, 2021 Author Share Posted September 3, 2021 Thanks - i have done just that and everything works fine. Bit of difficulty fitting the bodyshell back down so might have to re-solder some of the wires and make them shorter to save space. Plus trim back the function wires. I doubt I am going to be putting lights in this one. Link to post Share on other sites More sharing options...
Recommended Posts
Create an account or sign in to comment
You need to be a member in order to leave a comment
Create an account
Sign up for a new account in our community. It's easy!
Register a new accountSign in
Already have an account? Sign in here.
Sign In Now