update
Greetings.
Last night I installed two electromagnets and wired them to two push to make switches, which Have been added to the front switch plate. I have had these for a while in my box, and was looking for an opportunity to try them out.
I also have an unused memory wire kit, so might have a play and use this for the signal.
Installing the magnets was fairly straightforward - or it was until I realised I didn't need to drill right through the baseboard and sleepers to install them. As a result of this idiocy, I had to spend a further half hour filling in the resulting holes with DAS!
Cuckoo! Still theyare wired in and working now, I just hope theyare powerful enough to work through 10mm of .mdf and 2 layers of foamboard! If not I shall replace with permanent magnets.
I set up the DCC again tonight, because I had a nagging suspicion that all would not be great after applying the varous chemicals to the track. Sure enough, a good deal was required to get my 24 to run. Also one of the switch blades had comeloose I don't know how, so a bit more fettling was required.
The next job is the ballasting of the track.
I am going to follow Chris Nevards suggestions for this, namely to use surgical spirit as the wetting agent with diluted PVA. No more experiments with rubbery glue for me!
I have aquired a jar of fine, clean sand for the ballast. I think that N scale ballast is too heavy in appearance, and sand being naturally eroded I hear sits around the sleepers better.
I'm not sure whether to die the sand and dry it again before use; or to apply it then colour it afterwards.
Pictures next time when/if there is something to see.
Regards,
Chris
- 1
0 Comments
Recommended Comments
There are no comments to display.
Create an account or sign in to comment
You need to be a member in order to leave a comment
Create an account
Sign up for a new account in our community. It's easy!
Register a new accountSign in
Already have an account? Sign in here.
Sign In Now