Delph - Cosmetic chairs on first point
After what feels like a lifetime of back-aching effort, leaning over the board to focus my magnifying head set thingey, I have now completed fitting the cosmetic chairs to the point on the current board. Not only did thids involve cutting each chair in half to fit round the rivet, but also reguired lots of grinding of the rivet heads either side of the rails to enable a snug fit for the chair halves. On some, I didn't quite achive this, but the overall result is quite satisfying. I did consider only fitting chairs to the visible side of the rails, which would have halved the effort, but in the end I decided to fit both sides - must have too much time on my hands!!
I've also experienced some problem getting the point blades to throw over fully, especially on the diverging road. This was causing derailment of the loco front pony truck when travelling in the facing direction. This seems to have been solved by increasng the Tortoise throw to near maximum and an adjustment to the operating link to the TOU.
Photos show the completed point with BR Standard Cl2 tank being used to test the throw of the point. Also a close-up of the loco in its part completed condition.
Next to do on the track on this board is represent the rail joints by cutting through the rail head at the appropriate locations to represent 30 foot and 60 foot rail lengths. Intending to use a slitting disc on a flexible shaft drive for this. Then it's cosmetic fish plates.
Cheers for now,
Dave.
7 Comments
Recommended Comments
Create an account or sign in to comment
You need to be a member in order to leave a comment
Create an account
Sign up for a new account in our community. It's easy!
Register a new accountSign in
Already have an account? Sign in here.
Sign In Now