This part of the build is to join together the parts that need to be doubled up. These are soldered together then the drawing is glued on with pritt stick( other versions are available).

The frames are joined.

After glueing the drawing a quick check to see if it has stretched or twisted.

The other parts were done in the same manner.

I did find some Four Track horn guides and blocks. Which will work nicely. I have realised that I forgot to allow for the frames behind the wheels. This may be added later.

I also have some lovely cast brass springs, which seem to fit very well. Shhh I bought them sold as for GWR locos, so just keep quiet about it.

Finally parts that I managed lose, so re cut. The tank tops and inner sides. Might well need a driving wheel cut out.

Piercing saw out next t think.