A Bulleid style 2 HAP with Ayjay Models body shells and Hornby 2 BIL chassis
Another new project started: a 2 HAP unit of the 5601 - 5636 batch built to the Bulleid style.
This is based on the Ayjay Models resin kit, bought through Radley Models. As I intended to use Hornby 2 BIL running units and chassis, I asked Phil Radley if he could sell me just the body shells and seat units. He very kindly did this and included the floor/chassis units as well as he wanted only the bogies for other uses.
Having adapted the same manufacturer's 2 HAL unit to the 2 BIL chassis recently, I had a fair idea of what to look for this time. Modifications involve cutting/milling some notches out of the sides of the seating units, removing part of the seating unit on the motorised coach, and removing the buffer beams and fittings from the body shells. I also drill and ream out various holes in the floor or under the seats to clear some of the projections from the Hornby chassis and also the Lenz decoder. These holes can be covered over with a bit of thin plasticard later, before painting occurs.
The 2 BIL buffers will be replaced with non-sprung white metal castings for BR retracted buffers - this will be consistent with BR practice, where the Pullman buffing plates were normally used in conjunction with the buckeye couplings, and also with the Bachmann 4 CEP or 2 EPB units with which this one will be able to run. It could also run with a Hornby 4 VEP - I have a couple of photos (in reference books) of this occurring.
At this stage, I am planning to finish the unit in plain BR blue with full yellow ends, but I could change my mind before getting to that stage of the construction.
- 3
2 Comments
Recommended Comments
Create an account or sign in to comment
You need to be a member in order to leave a comment
Create an account
Sign up for a new account in our community. It's easy!
Register a new accountSign in
Already have an account? Sign in here.
Sign In Now