Emsford Mill - upward & onward!
Over a year since the last entry... Time to make some progress. The rear wall still requires 12 windows - but to be honest I needed something a little less taxing today, so I decided to tile the roof instead!
This will be done using laser-printed tile strips representing a standard clay tile. I usually produce roof & wall finishes on adhesive paper - but tiles need their thickness represented so they were printed on 200 micron (160 gsm) card - about postcard thickness. This was then reduced to individual strips...
In my experience, sticking them to the plasticard under-roof could be a challenge - PVA does not provide a good bond, and solvent-based adhesives ('Mekpak', 'Evostik') could a) affect the printing and b) require a very well ventilated room!
The answer is simple -
'felt' the roof with more of the afore-said adhesive paper, then attach the tile strips with thin PVA... Each strip carries a guideline' to assist in the overlap. The lowest tiles are of course a double-thickness layer, offset a half-tile.
The front roof is about half done! Guess whats on the agenda for tomorrow (and Friday)!
Regards
Ian
- 3
2 Comments
Recommended Comments
Create an account or sign in to comment
You need to be a member in order to leave a comment
Create an account
Sign up for a new account in our community. It's easy!
Register a new accountSign in
Already have an account? Sign in here.
Sign In Now