Do the European
No doubt someone can tell me what these locos are. Each one had three more pantographs than most electrics in the UK, presumably for multi-voltage operation. We waited 20 minutes to get a better picture without the catenary masts in the way, only to get 'bowled' by a poxy two-storey Dutch bogcart!
Yes, after talking about it for several years my pal and I finally got round to visiting the Eurospoor show in Utrecht, courtesy of Stena Line from Harwich to the Hook of Holland. I was well impressed by the ferry; very clean and modern with excellent food, but less so by the 0600 alarm call (0530 on the way back)! Eurospoor is about the same size as Warley but instead of being crammed into one hall it's in three and as a result is much more spread out and enjoyable. And the food was miles better, NEC take note. There was much less sound on display than I expected, but I was most impressed by the Viessmann working tamper with sound, and a G gauge layout with some of the best smoke / sound fitted steam locos that I've ever seen. I also marvelled at a small OHLE maintenance vehicle, apparently made by Fleischmann, with a working pantograph and an inspection platform that raised up and down and then rotated through 270 degrees. Hornby and Bachmann have still got a lot of catching up to do.
On the way back from Harwich we planned to do some photting but overlooked the fact that it would still be pitch black (and foggy) when we got off the boat. However, it was just getting light by the time we got to Manningtree, and we got some very atmospheric shots as a result. After a couple of hours there it was over to the ECML foot crossing at Offord Cluny (a 'Trainspot', and a truly excellent one at that). Being south of Peterborough it is very busy, with commuter EMU's adding to the usual ECML fare. The level crossing gives plenty of warning of approaching trains, and there are good pictures to be had in both directions from both sides of the track.
Back on the workbench, progress continues on the class 40 project which is about three-quarters done. So far there are just three engine notches (plus idle), but some very long transition sounds which add greatly to the experience. With the v3.5 chip long transitions were a bit of a no-no because they lengthen the throttle response time too much but with v4 it's different story as you can program your way out of them. I suspect there'll be room for a fourth notch (and hence four different ways of departing) before I'm finished.
4 Comments
Recommended Comments
Create an account or sign in to comment
You need to be a member in order to leave a comment
Create an account
Sign up for a new account in our community. It's easy!
Register a new accountSign in
Already have an account? Sign in here.
Sign In Now